CNC Start Checklist

Turn on machine and initiate warm-up.

Open and select the correct cut file for the job.

• Confirm correct bit is installed.
• For most files: use 1/4" compression bit.

• Verify waste board thickness is correct.
• F28 → set to 0.500 for clamping table.
• F28 → set to correct MDF thickness for other setups.

• Set vacuum hood heights to suit the job.
• F31.1 & F31.2 to change tools.
• 5mm plywood spacer for plywood.
• 1/2" pine spacer for Ergo Handles.

• Vacuum must be ON for plywood cutting.
• Zones 1–5 for 48" × 96" plywood.
• Zone 1 only for 14" × 48" plywood (2 sheets).
• Vacuum OFF for clamping table.

• Set to G56.
• X=96, Y=60 — 48" × 96" plywood.
• X=115, Y=40 — clamping table.
• X=66, Y=11 — yokes / 14" × 48" ply.